Projděte si akci Black Friday! Skvělé dárky k tiskárnám, slevy a doprava zdarma!
Ceny v měně
Doručení do
Všechny země
    Košík

    Prusa XL+ (Active Heater) Upgrade

    Loading...
    Odesílání začíná v lednu.
    Není skladem
    Není skladem
    $462.04
    Loading...
    $462.04Loading...

    IDF: 29815|IDS: 4637

    Prusa XL+ Active Heater UpgradeŘízené aktivní vyhřívání komory až na 60 °C pro technické materiály

    Aktivní výhřev komory usnadňuje tisk průmyslových materiálů, protože snižuje míru kroucení a zvyšuje soudržnost mezi vrstvami. Vylepšení lze nainstalovat na stávající 3D tiskárnu Prusa XL+ (5T) s Enclosure pro Prusa XL+.

    Better printability of engineering materials

    ASA, ABS, PA, PC, PP, HIPS and their filled variants (CF, GF) are easier to print at higher chamber temperatures. The elevated temperature reduces warping and improves layer bonding.

    Adjustable chamber temperature

    The chamber temperature is adjustable in 1 °C steps in a 40-60 °C range. This covers common engineering FFF/FDM 3D printing materials.

    Automated PrusaSlicer Integration

    You can set the chamber temperature on the printer and in PrusaSlicer via the filament profile (separate start-of-print minimum and nominal temperatures). The correct temperature is set automatically when you select a Prusa high-temp filament profile.

    Easy Installation

    The Prusa XL+ (Active Heater) Upgrade is easy to mount on an existing printer. It does not require any special skills or a large amount of time.

    Technical Parameters

    Heater power supply100–240 V AC, 50–60 Hz, max. 3.8 A
    Heater dimensions129 × 257 × 47 mm
    Operating conditions18–38 °C, max. 85 % humidity (non-condensing)
    Heater power320 W
    Heat-up time to 60 °C~18–21 min
    Energy consumptionheat-up ~360 Wh, holding ~240 W, ~0.46 kWh per print hour, standby ~15 W
    Filtration off during heatingrear fan must be off to reach 60 °C
    Maximum chamber temperature60 °C
    Adjustable temperature range40–60 °C
    Supported materialsASA, ABS, PA, PC, PP, HIPS and their filled variants (CF, GF). PLA/PETG are not intended for use with the heater
    Printer compatibility5-Head Prusa XL+ with Enclosure for Prusa XL+ only

    Frequently Asked Questions

    If yours isn't here, our support chat is ready to assist you!

    Recenze