United StatesSuperPINDA
SuperPINDA replaces the P.I.N.D.A. V2 (MK3/S, MK2.5/S) and M.I.N.D.A. (MINI).
When replacing the original probe with SuperPINDA make sure to use the 3.9.2 or higher firmware version.
SuperPINDA is temperature-independent, with higher quality sensor, and doesn't need a thermistor. Making the first layer calibration and mesh bed leveling much easier and consistent.
Compatible printer models: MK3/S/+, MK2.5/S, MINI/+
Not compatible with
This product includes:
- SuperPINDA (1 pcs)
To replace the part/s, please consult our Assembly Manuals. Make sure to follow the manual for your printer model.
Reviews
Easy broken, and even can't check the SuperPINDA's temperature.
Got two SuperPINDAs in two upgrade kits. Wasn't aware that chances are that the mesh bed level process will almost double in time depending on the SuperPINDA you get. Just be prepared for that. PRUSA support said that this is a normal behavior that does not warrant a replacement.
What they don't tell you about the SuperPINDA: As advertised the SuperPINDA as a higher quality, temperature-independent probe, compared to the PINDA. However, it has an important disadvantage compared to the [original] PINDA - slower bed meshing times. The higher quality of the SuperPINDA comes at a cost of slower speed. The FW setting for the SuperPINDA bed-levelling probing speed is at least two times slower than the same setting for the PINDA. Also, there is a delay in getting the SuperPINDA to a stable temperature level. The result is that mesh bed-levelling with the SuperPINDA takes a lot longer than with the [original] PINDA.
